Sheet Metal - Fictiv
Sheet Metal Specifications Guidelines
K-factors, bend radius, gauge charts, hole specs, welding, and cost optimization
+/- 0.005"
Tightest Tolerance
0.5°–1°
Bend Tol
0.015"-0.375"
Thickness Range
2-14 days
Lead time
Bending Guidelines▾
| Material | Min Bend Radius |
|---|---|
| Aluminum 5052 | 0.5t – 1.0t |
| Aluminum | 1.0t – 2.0t |
| Cold Rolled Steel | 0.5t – 1.0t |
| Stainless 304 | 1.0t – 2.0t |
| Copper | 0.5t – 1.0t |
K-Factor & Bend Relief▾
- K-FACTOR: Soft (AL) 0.33–0.40, Medium (Steel) 0.40–0.45, Hard (SS) 0.45–0.50
- RELIEF WIDTH: Material thickness or 0.030″, whichever is greater
- RELIEF DEPTH: 1.5× material thickness minimum
- MIN FLANGE: Standard 4× thickness, Absolute min 3×, Hems 5×
Holes & Cutouts▾
- Min hole Ø: 1.0× thickness (min 0.031″)
- Hole to edge: ≥2× thickness (min 0.062″)
- Hole to bend: ≥2.5× thickness + bend radius
- Countersink: 82° or 100°, max 60–70% depth
- Slots: Min width 1.0× thickness, radius ≥0.5× width
- PEM: Add 0.005–0.010″ clearance, min edge 2.5× hole Ø
Gauge to Thickness Chart +/-0.005"▾
| Gauge | Thickness | Gauge | Thickness |
|---|---|---|---|
| 30 ga | 0.012" (0.3mm) | 26 ga | 0.018" (0.5mm) |
| 24 ga | 0.024" (0.6mm) | 22 ga | 0.030" (0.8mm) |
| 20 ga | 0.036" (0.9mm) | 18 ga | 0.048" (1.2mm) |
| 16 ga | 0.060" (1.5mm) | 14 ga | 0.075" (1.9mm) |
| 12 ga | 0.105" (2.7mm) | 11 ga | 0.125" (3.1mm) |
| 10 ga | 0.135" (3.4mm) | 9 ga | 0.156" (3.9mm) |
| 7 ga | 0.188" (4.7mm) | 3 ga | 0.250" (6.3mm) |
Material Selection▾
- AL 5052-H32: Best forming, corrosion resistant
- AL 6061-T6: Structural, harder to form
- Cold Rolled Steel: Cost-effective, paintable
- Galvanized: Corrosion protection
- SS 304: Corrosion resistant, food grade
- SS 316: Marine, chemical resistant
- Copper: Electrical, decorative
Welding & Hardware▾
- Min for welding: 0.030″ (0.8mm)
- MIG: Steel, AL. TIG: Thin/SS. Spot: Assemblies.
- Edge prep for >0.125″. No galvanized welding.
- PEM nuts (0.040″+), studs (one-side), standoffs
Cost Optimization▾
- Use standard sheets (48×96″, 60×120″)
- Minimize bends, use standard radii
- Design for single setup/orientation
- Powder coat > wet paint usually
- Nest parts to minimize scrap